Click on any of the project photos above to learn more about it.
|
|
Walk and chew gum at the same time? It's Multi-tasking
- but we also enable Multi-tasking
on the BASIC Stamp® too!
Multi-tasking is the appearance, or actuality, of doing
more than one thing at a time. While very helpful, it ranges
from a challenge to nearly impossible to accomplish in many
popular processors used for hobby robotics.
All Co-Processors usually are multi-tasking by the fact of being
a separate processor. Our's is different because we also include
timers with our many other features. Those timers let you multi-task
on the main processor, even a BASIC Stamp, as well!
Besides the eight timers, our Co-Processor chip features-
- Eight
ramping servo controllers
|
- Five
channels of 10 bit A/D
|
- IR
Proximity Detector built in.
|
|
- And
even a Subsumption Engine for wheeled robots!
|
Click for the Features
of our Co-Processor Chip or see the Buy
page to buy the Co-Processor chip separately.
Learn More
about our Co-Processor kit
- The EASY way to add our Co-Processor
to your robot.
|
|
Some ideas for using a full featured Co-Processor!
Check out what you can do with our Co-Processor using
the AppMod connector on a BoE® based
Home Center Walker or a
BoE-Bot®.
But this Co-Processor isn't just limited to
robotics. The unique Timers allow it to increase the
performance of many Stamp applications.
|
|
The EASY way to add our Co-Processor to your BoE-Bot or Toddler!
Check out what you can do with our new Co-Processor
add-on board and a
BoE-Bot® or a
Parallax
Toddler.
Already have a
BASIC Stamp® based project?
Do you want to improve the processing and expandability?
Add this Co-Processor and get a SERIOUS increase in
capability!
|
|
The Robot Controller Circuit Board (PCB)
|
|
A high performance BASIC Stamp® 2p40 processor chip and
our premium Co-Processor were both included on this PC Board.
Schematics and programming information are on the site for your study.
|
|
|
Bumper hardware, IR components for IRPD
"vision", Dual Regulated Power Supplies for safety and performance,
and LOTS of connectors to use all that power! Here is
a runabout robot named Libby
and an animatronic head named Herbert
made with our controller board.
Our Co-Processor isn't just limited
to robotics. Animatronics, embedded control, and
data collection are also natural applications. One of our
customers plans to use a robot controller board to control
the heating system in his home!
Click for more Controller PCB Technical
info.
|
|
New to Hobby Robotics?
Want to learn more about hobby robots?
Click
here or on the tab
above for a basic discussion of Hobby Robots and a free source
for further reading. There is lots of good information for beginners
and experienced roboteers alike!
|
|
Click Here or on the Blue Bell Logo at
the top to return to Home. |
|
